Creative Craft Corner

Christmas Post-It Note Holders - How To

I have had quite a few emails and a few comments asking me for the instructions to the Christmas Post-It Note Holders as seen below...

So I thought I would attempt to explain how I made them.

Cut a piece of cardstock 8-1/2" x 3-1/4".

Score the cardstock at 2", 2-1/2", 5-3/4" and 6-1/4". 

Cut a piece of pattern paper 2-1/2" x 3-1/4" and score the pattern paper at 1/2".

Attach your pattern paper to the cardstock so that the 1/2" score line matches up with the 2" score line on the cardstock.  It should look something like this.

I used my crop-a-dile to punch two small holes for my ribbon to go through.

I cut a piece of ribbon approximately 8-1/2", threaded it through the holes and tied knots on each of the ends.  I then used my ATG to add adhesive to the back of the post-it note pad and attached inside. 

Next step is to add a closure of some sort....I used velcro.  Then decorate as you like.

I hope this helps you out.  If you have any questions just let me know!! 

Until next time...have fun creating!!

Karey

Masked Daisies

Here's another card I made using the masking technique.  Grab some cut outs (I used daisies), use some temporary adhesive to hold them in place and then take a sponge with ink and sponge around the cut outs.

 

Until next time...have fun creating!!

Karey

Masking with Post-it Notes

Here's another card using the masking technique.  I used post-it notes to mask around the white card stock in the middle to create the white border.

 

 

Until next time...have fun creating!!

Karey